1 - Sandblast with aluminum oxide. DO NOT USE glass bead or sand.

2 - Degrease with acetone, lacquer thinner, M.E.K . or similar non petroleum based material

3 - Spray with an airbrush or detail touch up gun or similar equipment, with fine spray pattern. Water based coatings spray at 50 to 60 psi; solvent based coatings spray at 35 to 40 psi.

Proper thickness is normally achieved with one wet, solid colored coat
For coatings that require oven curing, most coatings cure between 300f to 500f.

For retail packaged products, requiring baking, a standard kitchen oven or toaster oven may be used.

COATINGS OR SOLVENTS SHOULD NOT BE CURED IN ANY OVEN COMING IN CONTACT WITH FOOD.

Ceramic coatings can be sanded with 600 grit then 1500 grit wet dray paper then polished with a buffer.